Q-Logic 64 Manual do Utilizador descarregar pdf (Página 172)

B – Command Line Interface

Set Config Command

B-50 59043-03 A

The following is an example of the Set Config Port command:

SANbox2 #> admin start

SANbox2 (admin) #> config edit

SANbox2 (admin-config) #> set config port 1

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate this process before reaching the end of the list

press 'q' or 'Q' and the ENTER key to do so.

Configuring Port Number: 1

------------------------

AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online]

LinkSpeed (1=1Gb/s, 2=2Gb/s, 3=Auto) [Auto ]

PortType (GL / G / F / FL / Donor) [GL ]

SymPortName (string, max=32 chars) [Port1 ]

ALFairness (True / False) [False ]

DeviceScanEnable (True / False) [True ]

ForceOfflineRSCN (True / False) [False ]

ARB_FF (True / False) [False ]

InteropCredit (decimal value, 0-255) [0 ]

ExtCredit (dec value, increments of 11, non-loop only) [0 ]

FANEnable (True / False) [True ]

LCFEnable (True / False) [False ]

MFSEnable (True / False) [False ]

MSEnable (True / False) [True ]

NoClose (True / False) [False ]

IOStreamGuard (Enable / Disable) [Disable]

VIEnable (True / False) [False ]

Finished configuring attributes.

This configuration must be saved (see config save command) and

activated (see config activate command) before it can take effect.

To discard this configuration use the config cancel command.

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 243 244

Sem comentários

Q-Logic 64 Manual do Utilizador Página 172