Q-Logic Router 9120 Manual do Utilizador descarregar pdf (Página 8)

where -h ipaddress is the new IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format, and -m netMask

is the new subnet mask in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.

Step 7. To change the switch default gateway IP address enter:

setDefaultRoute -h ipaddress

where -h ipaddress is the new default gateway IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.

Step 8. To to exit the CLI enter:

logout

Using the Chassis Viewer

Step 1. Power up the switch.

Step 2. Connect a Category 5 or 6 (Cat 5/6) Ethernet cable to the RJ-45

connector on the switch. Connect the other end of the Cat 5/6 to a OOB LAN

workstation.

Step 3. To start Chassis Viewer, open a web browser and enter the IP of

the switch.

NOTE: The browser must be on a workstation connected to the same Ethernet LAN, and on the same TCP/IP subnet as the

switch RJ-45 OOB LAN port.

Step 4. From the main menu select OOB LAN IP then Set OOB LAN IP. The

following screen is displayed:

Figure 3. Set OOB LAN IP Window

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sem comentários

Q-Logic Router 9120 Manual do Utilizador Página 8